MaineDOT

News Release for October 17, 2017

For more Information:
Paul Merrill, Public Information Officer - 207-624-3355 or 207-215-9297

 

New lift span of the Sarah Mildred Long Bridge to be floated in on Wednesday

The float-in of the lift span for the new Sarah Mildred Long Bridge, which connects Kittery, Maine and Portsmouth, New Hampshire across the Piscataqua River, will take place the morning of Wednesday, October 18th.

Beginning on Tuesday morning the navigational channel will be closed to all vessels - from kayaks to tankers - within a 300-yard radius of the bridge. The nearly 3 million pound center lift span will be floated in on barges across the Piscataqua River between 10:00 a.m. and noon and positioned for the float in.

On Wednesday morning, between 6:00 a.m. and 9:00 a.m. the rising tide will lift the span to clear the bearings. Between 9:00 a.m. and noon the lift span will be put into position over the bearings. At 1:45 p.m. the outgoing tide will lower the lift span onto the bearings. Once resting on the bearings, the barge will be pushed to the state pier. Adequate clearance to remove the barge from under the lift span should occur at approximately 3:45 p.m.

Once complete and placed in-service, the new lift span will weigh approximately 4 million pounds or 2,000 tons. The new bridge alignment will improve marine navigation by increasing the navigational clearance allowing larger ships to access the port and shipyard. With a larger 56’ vertical clearance in its resting position, there will be 68% fewer bridge openings. 200’ tall precast concrete towers will support the 300’ long streamlined structural steel box girder lift span.

There are eight operating ropes (steel cables) that pull the counterweights up and down to lift and lower the bridge. If laid end to end these operating ropes would stretch over a mile and the forty counterweight ropes that support the four corners of the new lifts span would extend over 2 miles.

The float-in can be viewed from the banks of the river and can also be viewed via web cams on the SML Bridge Replacement Project website: http://maine.gov/mdot/sml/

The SML replacement project is a joint venture between the Maine and New Hampshire Departments of Transportation, with MaineDOT serving as the lead.

The design process began in 2013 and construction started in January of 2015. The new bridge was designed by a joint venture between specialty bridge design firms FIGG I Hardesty & Hanover. Maine-based Cianbro is the construction firm for the project.

The new Sarah Mildred Long Bridge is expected to open to traffic in November. The project is expected to cost approximately $160 million and is scheduled to be completed by June 1st, 2018.

###